On a 105 degree afternoon, an air conditioner that runs for hours is often doing exactly what it should. The question is whether it is keeping up. Here is how to tell the difference between a working system and one with a problem.
What is normal
Trane says longer run times in the hottest months are normal. A typical cycle is 20 to 30 minutes, with two to three cycles per hour. On extreme days the system may run almost continuously. What matters is whether the house reaches the thermostat setting at all, and whether it holds it once it gets there. A rough way to check is to note the cycle length at different outdoor temperatures. See AC running but not cooling in a heat wave.
Checks you can do
- Set the fan to Auto. A thermostat set to On runs the fan continuously, which can look like constant running.
- Replace the air filter. A dirty filter reduces airflow and cooling. See air filter sizes and MERV ratings.
- Keep a log of cycle lengths. Write down when the AC starts and stops, and the outdoor temperature. A technician can use it.
- Check the thermostat. Make sure it is set to Cool and that the setpoint is realistic. See thermostat not working.
- Look at the outdoor unit. Make sure the fan is spinning and that leaves and debris are not blocking it.
Do not clean evaporator coils with household cleaners. Trane advises against it.
Causes Trane lists
- A thermostat or wiring fault
- The fan set to On
- A welded contactor, which keeps the outdoor unit powered
- A dirty air filter
- A dirty evaporator coil
- An undersized unit
Trane says a technician will check the contactor, test the thermostat, clean the coil and perform a load calculation to confirm the sizing. A technician will also check the refrigerant charge and the ducts as part of a proper diagnosis.
When sizing is the problem
An undersized system cannot keep up on hot days, and it runs without end. An oversized system cycles too often and does not remove enough moisture. Neither is fixed by changing the thermostat. A load calculation based on ACCA’s Manual J shows the right size. See what size AC or heat pump do I need and AC keeps turning on and off for the opposite problem.
When to call
- The AC runs nonstop and the house does not cool
- The outdoor unit hums but the fan does not turn, or it runs when the thermostat is off
- Ice on the refrigerant line or the indoor unit. See why is my AC frozen.
- A sudden jump in your electric bill
If the system is old, see AC repair or replace and AC repair cost in Sacramento.
We repair air conditioners in Roseville, Rocklin, Folsom and Elk Grove. Contact us. Our diagnostic is a flat $69, credited toward the repair.
Frequently asked questions
Is it normal for my AC to run all day?
During the hottest days, longer run times are normal. Trane says a typical cycle is 20 to 30 minutes, with two to three cycles per hour. If the AC runs nonstop and the house still does not reach the thermostat setting, something is wrong.
Why does my AC never shut off?
Trane lists thermostat or wiring faults, the fan set to On, a welded contactor, a dirty filter, a dirty evaporator coil and an undersized unit. The first checks are free: set the fan to Auto and replace the filter.
What is the difference between fan On and Auto?
On runs the indoor fan all the time, even when the AC is not cooling. Auto runs it only during a cooling cycle. A thermostat set to On can make it seem like the system never stops.
Can the wrong size AC cause constant running?
Yes. An undersized system cannot keep up on hot days. An oversized one cools quickly and cycles off, then runs short cycles. Trane says a technician can do a load calculation to check the sizing.
Should I clean the evaporator coil myself?
No. Trane advises not cleaning evaporator coils with household cleaners. Coil cleaning is a technician task.