Heat Pump Installation in Elk Grove and Rocklin, CA

Levano Pro HVAC technician working on the wiring inside an open heating and cooling unit

Heat pumps are a common replacement in Elk Grove and Rocklin because one system heats and cools. The decision involves more than the equipment: your electric utility, the existing ducts and the rebate rules all change the picture. Here is what to check.

What a heat pump costs

Fixr’s 2026 heat pump guide lists $5,000 to $15,000 installed with an average near $8,350. Angi’s 2026 data is lower, around $4,200 to $7,900. The difference reflects what each guide includes. Our heat pump replacement cost guide covers local ranges. Ducts, electrical work and the type of system raise or lower the total.

Elk Grove and Rocklin have different utilities

Rocklin’s electricity comes from PG&E. In Elk Grove, SMUD serves most of Sacramento County, so check your bill to see which provider you have. This matters because rebates depend on the utility.

  • SMUD customers: SMUD’s HVAC page lists up to $3,000 for a variable-stage heat pump replacing gas heating, $2,000 for a two-stage system with at least 15.2 SEER2, and $1,000 for an electric-to-electric multi-stage system, all subject to funding. Single-stage systems are not eligible.
  • PG&E customers: we could not confirm a current residential heat pump rebate. TECH Clean California ran incentives that were reported closed to new reservations in late 2025, so check techcleanca.com for the current status.

The federal 25C credit ended on December 31, 2025. See SMUD heat pump rebates and heat pump tax credit 2026.

SMUD requirements to know before you hire

  • An active SMUD residential account that is individually metered
  • A contractor in the SMUD Contractor Network who submits the application
  • A passed Title 24 verification
  • New ductwork of at least R-8 where ducts are installed
  • A Wi-Fi 7-day programmable thermostat

Ask a contractor for the program rules in writing before you sign.

Permits

Rocklin says a permit is required for residential HVAC replacement and that it is usually issued over the counter, or through eTrakit. Elk Grove accepts same-location replacements through eTrakit and relocations through its building filedrop. A licensed contractor should apply for the permit. See HVAC permits in the Sacramento area.

Will it handle winter

Heat pumps keep heating below freezing, and backup heat covers the coldest hours. Winter operation includes frost and defrost cycles, which are normal. See heat pumps below freezing and heat pump running constantly. Avoid large manual thermostat setbacks, which can trigger expensive backup heat, as explained in our thermostat settings guide.

Heat pump or gas furnace

If you already have a good gas furnace and air conditioner, a heat pump may not make sense yet. If one needs replacing, a heat pump can replace both. Our heat pump vs furnace guide compares operating costs and trade-offs.

Questions to ask each contractor

  1. What is your CSLB license number, and are you in the SMUD Contractor Network?
  2. Did you do a load calculation, and may I see it?
  3. Which model is it, and is it single-stage, two-stage or variable-speed?
  4. What electrical work or panel upgrade is included?
  5. Who files the permit and the rebate?

We install and repair heat pumps in Roseville, Rocklin, Folsom and Elk Grove. See our heat pump services or contact us.

Frequently asked questions

How much does heat pump installation cost?

Fixr’s 2026 guide lists $5,000 to $15,000, with an average near $8,350. Angi’s 2026 data is lower, around $4,200 to $7,900. Your price depends on size, efficiency, ductwork and electrical work. See our heat pump replacement cost guide for local ranges.

Is there a rebate for a heat pump in Elk Grove?

If your electricity comes from SMUD, its program offers up to $3,000 for a variable-stage heat pump replacing gas heating and $2,000 for a two-stage system at least 15.2 SEER2, subject to funding. Rocklin is served by PG&E, and we could not confirm a current residential heat pump rebate there, so check TECH Clean California before you buy.

Do I need a permit for a heat pump?

Yes. Rocklin says a permit is required for residential HVAC replacement and that it is usually issued over the counter. Elk Grove accepts same-location replacements through eTrakit and relocations through its building filedrop.

Are single-stage heat pumps eligible for SMUD rebates?

No. SMUD says single-stage systems are not eligible. The program also requires a SMUD Contractor Network installer, a Title 24 verified install, new ductwork of at least R-8 and a Wi-Fi 7-day programmable thermostat.

Will a heat pump keep my home warm in winter?

In Sacramento winters, yes in most homes. Heat pumps still heat below freezing, with backup heat for the coldest hours. See our guide to heat pumps below freezing.