Our AC stopped cooling right in the middle of a heat wave. Called these guys in the morning and they had someone out the same day. The technician quickly found the issue, explained everything in simple terms, and had it …
What Our Customers Say
Real experiences from real Sacramento area homeowners.
Furnace Brands We Repair in Folsom
Parts for the builder-grade furnaces in the HOA neighborhoods and the high-efficiency attic units in the newer tracts.
Folsom runs colder than Sacramento, and the furnaces run longer
Folsom sits at the edge of the foothills, a couple of hundred feet higher than downtown Sacramento and far enough from the valley floor that the winter nights are noticeably colder. January lows here average roughly 38 to 41 degrees, and the cold snaps that barely register in Land Park put frost on windshields in Empire Ranch. A Folsom furnace runs more hours per winter than a Sacramento one, and it shows in what breaks.
It also means the mild-winter logic we use elsewhere applies a little less. A furnace that limps through a Sacramento winter half-broken fails in Folsom in December. So we tell people here to deal with the symptoms in October:
- Runs briefly and stops: filter, high-limit switch, or an oversized unit. See why a furnace keeps turning on and off.
- Runs but the air is cold: thermostat fan setting, igniter, flame sensor. See a furnace blowing cold air.
- Does nothing: breaker, power switch, door switch, float switch. See a furnace that will not turn on.
Diagnostic is a flat $69 anywhere in 95630 or 95763, credited toward the repair. Permits for equipment changes go through the City of Folsom, and we pull them.
Empire Ranch and Broadstone: late-1990s furnaces in HOA neighborhoods
Empire Ranch and Broadstone were built out in the late 1990s and early 2000s, and most homes there still have the furnace the builder installed: 80% AFUE, single-stage, in a hall closet or the garage, sized for the largest floor plan in the subdivision regardless of which one you bought. They are now twenty-five years old and reaching the end together.
What we replace on those units, in order of frequency:
- Hot surface igniter. Clicks, blower runs, no flame. A ceramic part that simply wears out.
- Flame sensor. Lights for three seconds, shuts off, tries again. Cleaning it is often the whole visit.
- Pressure switch or inducer motor. Tries to start and gives up before the burners light.
- Blower motor. On a 25-year-old furnace this is where we price the repair and the replacement side by side.
HOA neighborhoods add one thing: if a replacement involves moving equipment or adding a heat pump condenser, the HOA architectural rules may apply to where it sits. We have dealt with the Empire Ranch and Broadstone associations before and we handle that paperwork alongside the city permit.
Attic furnaces, condensate traps, and what actually fails in December
The newer tracts toward Folsom Ranch and the homes built since the mid-2000s mostly have high-efficiency condensing furnaces in the attic. They are more efficient and they have one more way to fail: they make water.
- The condensate trap clogs with sediment, water backs up, a pressure switch trips, and the furnace shuts off mid-cycle. From downstairs it looks dead. It is a clogged trap.
- The float switch in the pan under an attic furnace shuts the unit off when the pan fills, to keep water off your ceiling. Standing water in the pan is the diagnosis.
- The high-limit switch trips when a filter has gone unchanged, or when the return was never large enough for the furnace, which is common in the 1950s to 70s homes on the older side of town near Sutter Street and the Historic District.
Every furnace visit includes a combustion check and a carbon monoxide reading at the registers. If the heat exchanger is cracked, we show you, we shut the gas to the unit, and we do not talk you into repairing it. That is the one furnace job we turn down. If the furnace bangs when it lights, our guide to furnace noises explains why that cannot wait. For the summer side of the same house, see AC repair in Folsom.
Two utilities, one address: SMUD or PG&E decides the replacement math
Folsom has two electric utilities. Most of the city is on SMUD; some addresses are on PG&E. The line does not follow neighborhood names, so the only reliable check is the name on your electric bill or the address lookup on either utility’s site. Gas is PG&E everywhere.
It matters the moment a furnace repair turns into a replacement conversation. If your electricity is SMUD, replacing a gas furnace with a qualifying heat pump currently earns $3,000 for a variable-stage system or $2,000 for two-stage, plus up to $2,000 toward a panel upgrade, through a contractor in SMUD’s network. If your electricity is PG&E, those rebates do not apply and the picture is statewide programs when they are funded. Same street, different math. We confirm which utility you are on and what is open the day we quote.
On a furnace past fifteen years we show the repair number and the replacement number side by side, with the correct rebate applied, and we tell you which we would pick for our own house. Our guide to when to replace a furnace covers the four questions; heat pump vs furnace covers the utility side, including the cases where gas still wins.
Nearby: furnace repair in Sacramento and furnace repair in Roseville. Everything we do in the city is on HVAC in Folsom.
Furnace Repair in Folsom: Common Questions
The diagnostic is a flat $69 and it goes toward the repair if we do the work. Igniters, flame sensors and pressure switches are inexpensive parts and short visits. Blower motors and control boards cost more. A cracked heat exchanger is not a repair we do, and we say so before quoting anything.
Both. Most of the city is SMUD, some addresses are PG&E, and the line does not follow neighborhood names. Check the name on your electric bill. It matters because SMUD pays $2,000 to $3,000 toward a heat pump replacing a gas furnace and PG&E does not.
The condensate drain or trap clogged, water backed up, and the float switch shut the furnace off to protect your ceiling. Clearing the drain fixes it. The furnace itself is usually fine.
For an igniter, flame sensor or pressure switch, yes, at any age. For a blower motor or control board on a 25-year-old furnace, we price the repair and a replacement side by side so you can decide. A cracked heat exchanger is a replacement at any age.
All of 95630 and 95763: Empire Ranch, Broadstone, Folsom Ranch, Natoma Station, Briggs Ranch, the Historic District and Lake Natoma. We also cover El Dorado Hills, Rancho Cordova, Orangevale and Sacramento.